How to add Scooterheadz to a Micro Sprite

If you haven't heard, Scootaheadz are any kids fave addition to their scooter. Here's how to attach it to our best selling 2 wheel kids scooter, the Micro Sprite.

You will need: A cross head screwdriver, a 5mm Allen key and a 2mm Allen key

Instructions

1. Firstly, we need to remove the silver T Bar from the stem. Open the clamp lever and use a 5mm Allen key to loosen the bolt running through the clamp. Be sure not to fully remove the bolt from the clamp

2. Remove the small screw on the back of clamp using a smaller Allen key

3. Push in the push locking button and slide the T Bar up until it is removed from the stem of the scooter

4. Slide the clamp off the T Bar. Loosen the screw at the back of the handlebar clip using a cross head screwdriver and slide it down and off the T Bar. You will need to push in the locking button to remove the handlebar clip

5. Slide the clamp back on the T Bar and insert the T Bar back into the stem, holding down the push locking button until it clicks into place

6. Slot the clamp back into place. Reinsert the screw on the back of the clamp and tighten up the bolt running through the clamp using a 5mm Allen key

7. Adding your Scootaheadz: Firstly, attach the Scootaheadz to the T Bar first, then slot it into place on the handlebars. You may have to give it a good push until its in place